You need an account to access this content
Create a free account and get access to all downloads and more!
Paralleling Gen-set Controllers Training
Face to face
Parallel Gen-set Controller Training
R1,950.00 per person (excluding VAT)
Bedfordview, Johannesburg
English
21 - 22 August 2025 (2 days) and again 23 -24 October 2025
Capacity – 8 participants
The Paralleling Gen-set Controllers training takes a comprehensive approach, addressing complex configurations involving multiple generators in island or parallel operation. This program caters to participants at all stages of their professional journey, and it focuses on paralleling gen-set controllers including InteliGen 1000.
We advise all participants to complete the Single Gen-set Controllers Training prior to enrolling in this program.
Agenda
DAY 1
DAY 2
| 09:00 - 12:00 | Paralleling genset applications & controllers overview ComAp technical support and website introduction, general overview of paralleling applications, documentation, controllers and possibilities of extending their functionality. |
| 12:00 - 12:45 | Lunch break |
| 12:45 - 16:00 | Configuration Detail introduction of monitoring and configuration tools - InteliMonitor, GenConfig and WinScope. Controller software management - Firmware, Archive. Hands-on training with a paralleling genset controller on the genset simulator. Introduction of advanced functions and PLC editor. |
DAY 2
| 09:00 - 12:15 | Communications Internal and external communication modules (Internet Bridge NT, I-LB+), supported communication protocols. AirGate, ECU. Hands-on training on MODBUS RTU/TCP, IB-COM module. |
| 12:15 - 13:00 | Lunch break |
| 13:00 - 16:30 | Commissioning Commissioning and its important steps, checks before engine start, first start conditions (using Winscope), voltage and speed regulation, synchronization process, gensets paralleling, power management. |
| 16:30 - 17:00 | Test & Feedback |